Schneider ATV310H037N4E Inverter 0.37kW 3P Easy Line 380-460 VAC - ATV310H037N4E
Rp4.364.600 Rp2.400.500 45% off! Sale!
Schneider ATV310H037N4E Inverter 0.37kW 3P Easy Line 380-460 VAC
Schneider ATV310H037N4E Inverter 0.37kW Main Specification
- Easy Altivar 310 range of product
- Variable speed drive product type
- Simple machine product specific application
- With heat sink assembly style
- ATV310 device short name
- Three phase network number of phases
- 380 – 460 V / 15 – 10 % rated supply voltage
- 0.37kW motor power
- 0.5Â hp motor power
- 50 dB noise level
- Asynchronous motors product destination
- 1 quantity per set
- Without EMC filter
- Integrated fan type of cooling
- 50/60 Hz +/- 5 % supply frequency
- Modbus communication port protocol
- RJ45 (on front face) for Modbus connector type
- 2-wire RS 485 for Modbus physical interface
- RTU for Modbus transmission frame
- Transmission rate:
- 4800 bit/s
- 9600 bit/s
- 19200 bit/s
- 38400 bit/s
- 1 – 247 number of addresses for Modbus
Complementary
- Communication service:
- Read holding registers (03) 29 words
- Write single register (06) 29 words
- Write multiple registers (16) 27 words
- Read/write multiple registers (23) 4/4 words
- Read device identification (43)
- Line current:
- Apparent power:
- 5 kA prospective line Isc
- Continuous output current:
- Maximum transient current:
- Power dissipation:
- 0.5 – 400 Hz speed drive output frequency
- 4 kHz nominal switching frequency
- 2 – 12 kHz adjustable switching frequency
- 1 – 20 speed range
- 170 – 200 % transient overtorque of nominal motor torque depending on drive rating and type of motor
- Braking torque:
- Up to 150 % of nominal motor torque with braking resistor at high inertia
- Up to 70 % of nominal motor torque without braking resistor
- Asynchronous motor control profile:
- Energy saving ratio
- Energy saving ratio
- Sensorless flux vector control
- Motor slip compensation:
- Preset in factory
- Adjustable
- 380 – 460 V three phase output voltage
- Electrical connection terminal, clamping capacity: 1.5-2.5 mm² (L1, L2, L3, PA/+, PB, U, V, W)
- 1.2 – 1.4Â N.m tightening torque
- Electrical between power and control insulation
- Supply:
- Internal supply for reference potentiometer: 5 V (4.75…5.25 V)DC, <10 mA with overload and short-circuit protection
- Internal supply for logic inputs: 24 V (20.4…28.8 V)DC, <100 mA with overload and short-circuit protection
- Configurable analogue input:
- Current AI1 0-20 mA 250 Ohm
- Voltage AI1 0-10 V 30 kOhm
- Voltage AI1 0-5 V 30 kOhm
- 4 discrete input number
- Programmable discrete input type LI1…LI4 24 V 18…30 V
- Discrete input logic:
- Negative logic (sink), > 16 V (state 0), < 10 V (state 1), input impedance 3.5 kOhm
- Positive logic (source), 0 – < 5 V (state 0), > 11 V (state 1)
Environment
- Sampling duration:
- 10 ms for analogue input
- 20 ms, tolerance +/- 1 ms for logic input
- +/- 0.3 % of maximum value linearity error for analogue input
- 1 analogue output number
- Analogue output type:
- AO1 software-configurable voltage: 0…10 V, impedance: 470 Ohm, resolution 8 bits
- AO1 software-configurable current: 0…20 mA, impedance: 800 Ohm, resolution 8 bits
- 2 discrete output number
- Discrete output type:
- Logic output LO+, LO-
- Protected relay output R1A, R1B, R1C 1 C/O
- 5 mA minimum switching current at 24 V DC for logic relay
- Maximum switching curren:
- 2 A at 250 V AC on inductive load cos phi = 0.4 L/R = 7 ms for logic relay
- 2 A at 30 V DC on inductive load cos phi = 0.4 L/R = 7 ms for logic relay
- 3 A at 250 V AC on resistive load cos phi = 1 L/R = 0 ms for logic relay
- 4 A at 30 V DC on resistive load cos phi = 1 L/R = 0 ms for logic relay
- Braking to standstill By DC injection, <30 s
- Protection type:
- Line supply overvoltage
- Line supply undervoltage
- Overcurrent between output phases and earth
- Overheating protection
- Short-circuit between motor phases
- Against input phase loss in three-phase
- Thermal motor protection via the drive by continuous calculation of I²t
- Frequency resolution:
- Analog input: converter A/D, 10 bits
- Display unit: 0.1 Hz
- 20 ms +/- 1 ms time constant for reference change
- Vertical +/- 10 degree operating position
- Standards:
- EN/IEC 61800-5-1
- EN/IEC 61800-3
- IP degree of protection:
- IP20 without blanking plate on upper part
- IP40 top
- 2 pollution degree conforming to EN/IEC 61800-5-1
Variable Speed Drive 380 – 460 VAC Easy Line ATV310 3P – 0,37kW
Out of stock
Reviews
There are no reviews yet.